Markisolette for vertical windows VMB

Markisolette has similar features as the awning blind, but it differs in terms of structure. The Markisolette comes with a special tilting bar which creates a small roof over part of the window. Thanks to this design, the Markisolette has a material with very dense weave and low heat transmittance, ensuring enough amount of natural light inside. This solution also enables easy access allows an outside view.

The markisolette can be controlled in one of two modes:

• automatic (self-activating rolling up and unrolling dependent on the level of insolation)
• semi-automatic (self-activating unrolling, rolling up via a remote control)
• operation via remote control supplied

• VMB Z-Wave – powered by 15VDC mains supply and operated by means of a remote control or wall switch in the wireless Z-Wave system. It cooperates with FAKRO electric products equipped with the Z-Wave system (e.g. FTP-V Electro Z-Wave window or ARF Z-Wave blackout blind). In special cases, the awning can be controlled by a service button situated on it. A 15VDC power supply is required to power the awning.
• VMB Solar – powered by solar battery and operated by means of a remote control. In can be controlled using three modes:
  • automatic (self-activating rolling up and unrolling dependent on the level of insolation). In summer mode, the awning blind protects against excessive heat gain on a sunny day. In colder months, it is possible to manually switch the awning into winter mode. In this mode, in sunny weather, the awning rolls up automatically to allow the flow of warm sun rays, passively heating up the room. At low insolation level (from afternoon to morning or in cloudy weather) the awning is automatically rolled down to protect the room from heat loss.
  • semi-automatic (self-activating unrolling, rolling up via a remote control).
  • operated via supplied remote control. The Solar awning blind is powered by a 15VDC battery pack which is built into the cassette and recharged by the solar panel*.
• VMB Electro 230  – powered by mains supply and operated via a wall switch (switch must be purchased separately). No power supply is required for the blind – the blind can be connected to 230V mains supply.
• VMB Electro 12 – powered by 15VDC mains supply and operated via a wall switch (switch must be purchased separately). In special cases, the awning can be controlled by a service button situated on it. A 15VDC power supply is required to power the awning.
• VMB Electro Solar – powered by the solar panel (battery pack included) and operated by means of a wall switch (switch must be purchased separately). In special cases, the awning can be controlled by a service button situated on it.*

* The Solar type awning blinds should be fitted in places with the solar panel positioned to direct sun exposure. It is recommended to install awnings on south, east and west-facing roofs. Installation in the north side may result in battery discharge and the inability to operate the blind. To ensure correct operation of the automatic mode, the solar panel must be exposed to direct sun sunlight throughout the active operation mode.

* In awning blinds with fabric 089, where the width exceeds 2100mm, the fabric consists of two parts and is joined together in the middle of the awning (horizontal welded connection).

* In awning blinds with fabric featuring 1% relative open area, where the width exceeds 2400mm, the fabric consists of two parts and is joined together in the middle of the awning (horizontal welded connection).

* In markisolettes with fabric 351, 353, 354, 356, 357, 360, 361, 362, 363, 364, 365, 366 ,367, 368, 369, where the width exceeds 1250 mm, the fabric consists of two or three parts and is joined together in the middle of the markisolette (welded and sewed vertical connection).